Lune bench flasher

1.75 in round AMOLED (ESP32-S3, 466 x 466). Cove at native resolution and true millimetre scale.

Load the test

  1. Use Chrome or Edge on a computer. Plug the board in by USB-C.
  2. Click the button, pick the port that appears, then Install.
  3. Wait for 100% (about 3 to 6 minutes). The board restarts and plays.
This browser can't talk to USB boards. Open this page in Chrome or Edge on a computer. Open this page directly in its own browser tab.

No port listed? Unplug, hold the BOOT button, plug back in, let go, and click again.

On the board

It starts with red, green and blue dots for 3 seconds (if red and blue look swapped, hold BOOT for 4 seconds). Then press BOOT to step through:

1. DayCove by Day, panel at 85%.
2. NightCove at Night, panel at 12%.
3. Brightness stepsNight clip at 40, 20, 10, 5, 2 and 1%. The dots at the bottom show which step. Film this in slow motion to check flicker.
4. Slow fadeNight clip fading from 40% down to 0.5% and back, to check for banding or blotches.
5. BlackPure black at three brightness settings. It should stay fully black in a dark room.

Frame rate

After installing, click the button again and choose Logs & Console. Every 5 seconds the board prints a line like 59.9 fps, decode avg 9 ms, send avg 12 ms.